Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Robla, CA
Gate installation in Robla, CA usually starts around $1,200 for a basic chain-link driveway gate and runs $4,500 to $9,500 for a steel or aluminum automatic gate with an operator. Most jobs in this 95838 pocket involve replacing a sagging original gate on a 1950s-to-1970s ranch home rather than building from scratch. Gate Repair Del Paso Park has served Robla since 2012, and we carry parts for LiftMaster, FAAC, Mighty Mule, and Elite systems so you aren’t waiting on a backorder. Call (833) 620-4636 for a free site measure and written quote.
Why Robla Homes Are Different
Robla is a small, unincorporated north Sacramento neighborhood where the housing stock runs heavily to mid-century ranch tract homes on flat, oversized lots. Most properties still have their original wood picket or chain-link fencing, and the gates hanging off those fences were typically installed with the house 50 to 70 years ago. That means the gate itself may be salvageable while the post it swings from has rotted, leaned, or heaved out of level.
The Sacramento Valley climate does specific damage here. Summers bake wood gate frames until they crack and pull at the hinges. Winter rains soak the valley’s heavy clay soil, which swells and shifts, pushing posts out of alignment. A gate that closes cleanly in August can drag against the ground by February. We see far more hinge failure, post rot, and latch misalignment in Robla than motor failure on an installer’s first visit. For installations, we set posts deeper than the original builders did and use treated or steel posts where the soil tends to hold water.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Main Robla Services
Robla homeowners call us for two things most often: a gate that no longer swings or latches, and an electric gate that stopped responding to remotes or keypads. Both are covered below.
Gate Repair in Robla
A wood or chain-link gate in Robla typically fails at the hinges, the post base, or the latch, and the fix usually means rehanging the gate on fresh hardware rather than replacing the whole assembly. We straighten leaning posts, replace rotted wood posts with steel or treated alternatives, and re-weld or re-bolt chain-link frames that have pulled apart. Because lots here are flat and gates are usually side-yard or driveway-width, we can complete most repairs in a single visit. See our dedicated Gate Repair in Robla page for full pricing and what to expect.
Electric Gate Repair in Robla
When a gate opener in Robla quits, the culprit is usually the control board, a burned-out transformer, a failed safety sensor, or a remote that lost its programming, not the gate itself. We work on residential systems like Mighty Mule and LiftMaster as well as commercial-grade FAAC and Elite operators. Our technicians diagnose the motor, board, and sensors on site and stock common replacement parts in the truck. Read more on our Electric Gate Repair in Robla page.
Gate Installation in Robla
A new gate in Robla usually replaces an original 1960s or 1970s gate that has sagged past repair, or adds a driveway gate where the property never had one. Because most lots here are flat and wide, driveway gates are the most common installation, followed by side-yard gates that close off the long side access running between the house and the fence line. We handle everything from a basic chain-link gate to a fully automated steel or aluminum driveway gate with keypad entry. For a complete look at what a new gate involves, see our Gate Installation hub page.
Automatic Gate Installation
Signs you need it
You’re tired of getting out of the car to open a gate, or you need controlled access to a driveway that currently has no gate at all.
What it costs in Robla
Automatic gate installation in Robla typically runs $4,500 to $9,500 for a complete steel or aluminum gate and operator, including the motor, control board, safety edges, and a keypad or remote kit.
How we do it
We measure the driveway opening, set steel posts below grade in concrete, hang the gate, mount the operator, run the power and safety wiring, and program all remotes and keypads before we leave.
Driveway Gate Installation
Signs you need it
Your existing driveway gate has sagged, rusted through, or been hit and can no longer be repaired economically, or you want to secure a driveway that has never had a gate.
What it costs in Robla
A new chain-link driveway gate in Robla starts around $1,200, while a steel or aluminum driveway gate with no automation typically costs $2,000 to $5,000 depending on width, material, and hardware.
How we do it
We remove the old gate and hardware, set new posts if the existing ones are out of level or rotted, hang the new gate, align the latch, and test swing clearance both directions.
Sliding Gate Installation
Signs you need it
Your driveway slopes enough that a swinging gate would drag, or you have a narrow setback that won’t accommodate a swing gate’s arc.
What it costs in Robla
Sliding gate installation in Robla generally runs $3,500 to $8,000, with the higher end covering automated cantilever or track systems with steel frames.
How we do it
We pour a level concrete track or set cantilever rollers, frame the gate to the exact opening width, install the motor and safety edges, and adjust travel limits until the gate opens and closes smoothly.
What Gate Installation Costs in Robla
| Item | Typical range in Robla |
|---|---|
| Chain-link driveway gate, manual | $1,200 – $2,000 |
| Steel or aluminum driveway gate, manual | $2,000 – $5,000 |
| Automatic gate with operator and keypad | $4,500 – $9,500 |
Do you handle the power run and safety edges?
Yes. We run the low-voltage and line-voltage wiring, install safety edges and photo sensors, and wire the keypad. We do not leave a gate automated unless every safety device tests working.
Will a new gate work with my existing opener?
Often, yes. If your operator is a LiftMaster, FAAC, Mighty Mule, or Elite unit in good shape, we can usually hang a new gate and reuse it. We check motor wear before quoting so you don’t pay for a new operator unnecessarily.
Brands We Service in Robla
We repair and install LiftMaster, FAAC, Mighty Mule, and Elite systems across Robla, with common control boards, remotes, and safety parts stocked on our trucks. That means most electric gate repairs here finish the same day. See our brands for the full list we service.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Robla, CA
| Service | Typical range in Robla |
|---|---|
| Gate repair service call | $75 – $150 |
| Hinge replacement | $150 – $450 |
| Post repair or reset | $250 – $750 |
| Wood gate rehang | $250 – $600 |
| Chain-link gate rehang | $200 – $500 |
| Electric gate diagnostic | $90 – $200 |
| Control board replacement | $350 – $1,200 |
| Safety sensor or edge replacement | $200 – $500 |
| Chain-link driveway gate, manual | $1,200 – $2,000 |
| Automatic gate with operator and keypad | $4,500 – $9,500 |
In Robla, the biggest price shifters on repairs are post condition and gate weight. An original post set in valley clay 60 years ago is often rotted below grade, which adds a post replacement to a simple hinge job. On installations, automation accounts for most of the spread between a $1,500 manual gate and a $9,000 full system. Every job is quoted in writing before work begins, and that number does not change unless you ask us to add scope while we’re there.
Neighborhoods We Serve in Robla
We cover the entire 95838 zip code, including the residential streets that run between Marysville Boulevard and the rail corridor, plus the side streets off Norwood Avenue. Our trucks are typically in Robla the same day for repairs and within a day or two for installation measures.
- Robla proper, north of El Camino
- Streets off Marysville Boulevard
- Norwood Avenue corridor
- South Robla near the 80 corridor
- West side of 95838
Service Area – Cities Near Robla
Robla is centrally located for our north Sacramento routes. We also cover Natomas Park, CA, North Sacramento, CA, Del Paso Park, CA, and Point West, CA. If you’re just outside the 95838 boundary, call and we’ll confirm the next available route.
Serving Robla, CA – Our Local Coverage Area
We’re based in the Robla area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Robla
Most Robla repair calls are scheduled same day or next day. Our shop is minutes from the neighborhood, so a stuck-open gate or a dead operator doesn’t leave your property unsecured overnight. Call before noon for the best chance of same-day service.
For a like-for-like gate replacement on an existing fence line, no permit is usually needed in unincorporated Robla. Adding a new driveway gate with automation can trigger a permit check depending on setback and power. We confirm the requirement before quoting.
Yes. For 1950s and 1960s ranch homes, we match the original gate proportions and hardware style, and we can build wood or steel to match existing fence lines. A replacement should look like it belongs to the house, not like a stock panel from a catalog.
If your gate is sagging, stuck, or has an opener that quit, call (833) 620-4636. We’ll give you a straight diagnosis and a free written estimate, and the price we quote is the price you pay.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within 60 minutes.
- 4You approve before work beginsNothing starts until you say go.
What Robla Customers Say
"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
- Marisol Salazar"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
- Tiana Coleman"Our slide gate had been dragging for months and getting worse. Turned out the chain was stretched and one of the guide rollers had seized. Both replaced, and he adjusted the limits so it stops properly at both ends now."
- Ramon Mendoza