Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Folsom, CA
Gate installation in Folsom runs $2,800 to $9,500 for most residential automatic driveway gates, and the exact number depends on whether you’re fitting a wrought-iron pedestrian gate near Sutter Street or a sliding operator across a wide Empire Ranch driveway. We’re Gate Repair Del Paso Park, and we’ve handled both ends of that range. Folsom’s mix of Gold Rush-era homes and 1990s-2010s semi-custom subdivisions means every install starts with the same question: what does the HOA or historic district allow, and what does the sun and wind do to this gate by August? Call (833) 620-4636 for a free estimate.
Why Folsom Homes Are Different
Folsom splits into two gate markets, and they fail in different ways. Around Sutter Street and the older core, you’ll find wood picket and wrought-iron pedestrian gates mounted on homes from the early 1900s and before. Those gates swell in winter rain and shrink in summer heat, so the hardware loosens, the latch drifts, and the gate starts dragging on the walkway. Up in Empire Ranch, Broadstone, and the hillside subdivisions built from the 1990s onward, the story is different: wide lots, long driveways, and rolling or sliding automatic gates that sit in full sun from noon to seven. Operator control boards bake. Limit switches get gritty from wind-blown dust off the open land. Gate arms fatigue from constant thermal cycling.
Folsom’s summers in the Sacramento Valley are dry and hot, with gusty north winds that push fine grit into everything. That combination accelerates wear on hinges, rollers, and sensor lenses far faster than in shaded, closer-in Sacramento neighborhoods. We adjust for it: heavier grease on pivot points, sealed sensor housings where possible, and hardware sized for the extra solar load. A gate that would last fifteen years in Land Park might need real attention at eight years out here.
There’s also a design compliance layer most cities don’t have. Folsom’s Gold Rush-era character plus its many gated planned communities means replacement gates often need to clear HOA design review or respect historic-district expectations. Swapping a cedar or wrought-iron gate for something off-style in the old town can trigger a compliance headache. We check that before recommending anything, because a beautiful gate that gets you fined isn’t a good install.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Main Folsom Services
Most Folsom calls start with one of two problems: a gate that won’t move, or an operator that moves it when it shouldn’t. Here’s what each involves in this area.
Gate Repair in Folsom
Structural gate repair covers hinges, frames, posts, pickets, sagging corners, and latch failures. In Folsom, the most common call is a wood gate that’s swelled or warped from seasonal moisture shifts, especially on older homes near Sutter Street where the gate may be original to the property. We straighten, re-hang, and reinforce before recommending replacement. If the post is rotted at ground level, we address that too. For the full scope of what we fix, see Gate Repair in Folsom.
Electric Gate Repair in Folsom
Electric gate repair is where Folsom’s heat shows up most. Motors, control boards, photo eyes, remote receivers, and loop detectors all fail faster here than in cooler parts of the region. We diagnose on site, and because we carry parts for nine major operator brands, most repairs happen in one visit. That includes Ghost Controls and Mighty Mule residential systems as well as FAAC and DoorKing commercial units. Read the full breakdown at Electric Gate Repair in Folsom.
Gate Installation in Folsom
Gate installation in Folsom usually means one of two jobs: adding an automatic driveway gate to a wide-lot home in a subdivision like Empire Ranch or Broadstone, or replacing a worn-out pedestrian gate on an older home near the historic core. The climate shapes both. Long dry summers mean we size hardware and operators for heat, sun exposure, and wind-blown grit, not just load weight. And the HOA or historic-district layer means we confirm design rules before any material gets ordered. We cover the full process under our Gate Installation service, from measure to final operator programming.
Automatic Gate Installation
Signs you need it
You want driveway access control, you’re tired of getting out to open a gate in Folsom heat, or your manual gate now needs automation for security on a wider lot.
What it costs in Folsom
Automatic gate installation in Folsom typically runs $3,200 to $8,500 depending on gate size, operator type, and whether power needs to be trenched to the gate.
How we do it
We measure the opening and grade, confirm HOA requirements, set posts for the gate and operator, mount and configure the motor, and test safety loops and remotes before leaving.
Electric Gate Installation
Signs you need it
You’re putting in a new gate altogether, not automating an existing one, and you want the operator, wiring, and safety edges planned as one system from day one.
What it costs in Folsom
Electric gate installation in Folsom typically runs $4,500 to $9,500 when it includes the gate leaf, operator, control board, safety devices, and the electrical run.
How we do it
We handle the full scope: gate fabrication or ordering to spec, post setting, operator mounting, low-voltage wiring to the house or a local transformer, sensor alignment, and remote programming.
Driveway Gate Installation
Signs you need it
Your driveway is wide enough that a single pedestrian gate won’t work, and you want either a sliding or swing gate sized to the full opening.
What it costs in Folsom
Driveway gate installation in Folsom typically runs $3,800 to $9,000 depending on whether it’s a swing or slide, the material, and the operator brand you’re pairing with it.
How we do it
We check the driveway slope and swing clearance, set posts or a track, hang the gate, mount the operator, and wire photo eyes and edge sensors to meet current safety standards.
Sliding Gate Installation
Signs you need it
Your driveway slopes upward or there’s not enough flat space for a swing gate to arc open, so the gate needs to track sideways instead.
What it costs in Folsom
Sliding gate installation in Folsom typically runs $4,000 to $9,500, with the higher end reflecting longer gates, cantilever setups, or commercial-grade operators.
How we do it
We set the track or cantilever footing, hang the gate so it carries its own weight, mount the operator, and dial in the limit switches and safety sensors for the full slide path.
What Gate Installation Costs in Folsom
| Item | Typical range in Folsom |
|---|---|
| Automatic gate installation | $3,200 – $8,500 |
| Electric gate installation | $4,500 – $9,500 |
| Sliding gate installation | $4,000 – $9,500 |
Does a Folsom automatic gate require a permit?
Yes in most cases. Folsom requires permits for new automatic gates, and many subdivisions add HOA design review on top. We confirm both before ordering materials, and the permit cost is separate from the install price. Call us at (833) 620-4636 to check your specific street.
How long does a driveway gate install take in Folsom?
Most residential driveway gate installations take one to three days from post setting to final programming, assuming no HOA delay. Custom iron or redwood gates add lead time for fabrication. We quote the schedule at the free measure, and the price is fixed before work starts.
Brands We Service in Folsom
We work on your brand, not just gates in general. In Folsom we regularly service Ghost Controls and Mighty Mule on the residential side, plus DoorKing and Elite for heavier-duty and commercial work. We stock common boards, arms, and remotes locally. See our brands for the full operator list and what we carry.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Folsom, CA
| Service | Typical range in Folsom |
|---|---|
| Gate repair (hinge, latch, realignment) | $155 – $390 |
| Automatic gate installation | $3,200 – $8,500 |
| Electric gate installation | $4,500 – $9,500 |
| Driveway gate installation | $3,800 – $9,000 |
| Sliding gate installation | $4,000 – $9,500 |
| Electric gate repair (diagnostic + board/motor) | $290 – $690 |
In Folsom, price gets pushed up by long underground wire runs from the house to a gate at the back of a deep lot, by hillside grades that need cantilever sliding setups, and by HOA-required materials or finishes. Whatever the number, it’s quoted and agreed before any work starts, so there’s no surprise invoice at the end.
Neighborhoods We Serve in Folsom
We work across Folsom’s older core and its newer hillside subdivisions. Response time for most calls is same-day or next-day depending on when you reach us.
- Empire Ranch
- Broadstone
- Historic Sutter Street area
- Folsom Heights
- Prairie Oaks
Service Area – Cities Near Folsom
We also cover nearby communities in the northeast Sacramento Valley, where the climate conditions are similar though each town has its own housing mix. That includes Fair Oaks, CA, Citrus Heights, CA, Roseville, CA, and Rocklin, CA. If your gate is on the edge of Folsom or you manage properties across the county line, call us and we’ll confirm coverage.
Serving Folsom, CA – Our Local Coverage Area
We’re based in the Folsom area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Folsom
Most Folsom calls get same-day or next-day dispatch. A gate stuck open is a security issue, so we prioritize those. Call (833) 620-4636 as soon as you notice the failure and we’ll give you a straight arrival window.
We confirm the design rules before recommending a replacement gate or operator. That means checking the HOA’s material, height, and color restrictions, plus any historic-district requirements near Sutter Street. We don’t file the HOA application for you, but we give you what you need to file it without delays.
We serve Folsom proper including zip codes 95671, 95630, and 95763, and we take calls from Empire Ranch, Broadstone, and the older core near Sutter Street. We also work in Fair Oaks, Citrus Heights, Roseville, and Rocklin. If you’re just outside those, call and we’ll tell you honestly whether we can get there same week.
Need gate work in Folsom? Call Gate Repair Del Paso Park at (833) 620-4636 for a free estimate. We’ll name the problem, give you a fixed price, and get it fixed. From a stuck residential gate to a full automatic install, one call covers it. Electric gate specialists, not generalists.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within 60 minutes.
- 4You approve before work beginsNothing starts until you say go.
What Folsom Customers Say
"Photo eye was misaligned so the gate refused to close after dark. Ten minute fix. He also cleaned the lens and pointed out that the sprinkler head was spraying it every morning, which is why it kept happening."
- Gilbert Martinez"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
- Arjun Patel"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
- Marisol Salazar